gc01mps12 - 214 1200 v sic mps? diode feb 2018 rev1.1 http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ silicon carbide power schottky diode features ? high avalanche (uis) capability ? enhanced surge current capability ? 175 c maximum operating temperature ? temperature independent switching behavior ? positive temperature coefficient of v f ? extremely fast switching speeds ? superior figure of merit q c /i f advantages ? low standby power losses ? improved circuit efficiency (lower overall cost) ? low switching losses ? ease of paralleling devices w ithout thermal runaway ? smaller heat sink requirements ? low reverse recovery current ? low device capacitance ? low reverse leakage current a t operating temperature absolute maximum ratings parameter repetitive peak reverse voltage continuous forward current non-repetitive peak forward surge current, half sine wave repetitive peak forward surge current, half sine wave non-repetitive peak forward surge current i 2 t value non-repetitive avalanche energy diode ruggedness power dissipation operating and storage temperature electrical characteristics parameter diode forward voltage reverse current total capacitive charge switching time total capacitance thermal / mechanical characteristics thermal resistance, junction - case http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ package do-214 applications overall cost) ithout thermal runaway t operating temperature ? power factor correction (pfc) ? switched- mode power supply (smps) ? solar inverters ? wind turbine inverters ? motor drives ? induction heating ? uninterruptible power supply (ups) ? high voltage multipliers symbol conditions value v rrm 1200 i f t c = 25 c, d = 1 3 t c = 135 c, d = 1 2 t c = 158 c, d = 1 1 i f,sm t c = 25 c, t p = 10 ms 10 t c = 150 c, t p = 10 ms 8 i f,rm t c = 25 c, t p = 10 ms 6 t c = 150 c, t p = 10 ms 3 i f,max t c = 25 c, t p = 10 s 65 i 2 dt t c = 25 c, t p = 10 ms 0.9 e as l = 60 mh, i av = 1 a, v dd = 60 v 20 dv/dt v r = 0 ~ 960 v 100 p tot t c = 25 c 19 t j , t stg - 55 to 175 symbol conditions values min. typ. v f i f = 1 a, t j = 25 c 1.5 i f = 1 a, t j = 175 c 2.3 i r v r = 1200 v, t j = 25 c 0.1 v r = 1200 v, t j = 175 c 0.8 q c i f i f,max di f /dt = 200 a/s t j = 175 c v r = 400 v 4 v r = 800 v 6 t s v r = 400 v < 10 v r = 800 v c v r = 1 v, f = 1 mhz, t j = 25 c 68 v r = 800 v, f = 1 mhz, t j = 25 c 4.5 r thjc 7.72 v rrm i f (tc = 1 3 q c 1 2 http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ page 1 of 6 mode power supply (smps) s unit 1200 v a a a a a 2 s mj v/s w 55 to 175 c values unit max. 1.8 v 2.7 1 a 9 nc ns pf c/w = 1200 v 3 5c) = 2 a = 6 nc
gc01mps12 - 214 1200 v sic mps? diode feb 2018 rev1.1 http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ i f = f(v f ,t j ); t p = 300 s figure 1: typical forward characteristics i r = f(v r ,t j ) figure 3: typical reverse characteristics http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ s i f = f(v f ,t j ); t p = 300 figure 1: typical forward characteristics figure 2: typical high current forward characteristics p tot = f(t j ) figure 3: typical reverse characteristics figure 4: power derating curve http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ page 2 of 6 = 300 s figure 2: typical high current forward characteristics power derating curve
gc01mps12 - 214 1200 v sic mps? diode feb 2018 rev1.1 http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ c = f(v r ); t j = 25 c ; f = 1mhz figure 5 : typical junction capacitance vs reverse voltage characteristics figure 7 : typical capacitive energy vs. reverse voltage http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ ; f = 1mhz q c = f(v r ); t j = 25 c ; f = 1mhz : typical junction capacitance vs reverse voltage characteristics figure 6: t ypical capacitive charge vs. reverse voltage characteristics e c = f(v r ); t j = 25 c; f = 1mhz : typical capacitive energy vs. reverse voltage characteristics http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ page 3 of 6 ; f = 1mhz ypical capacitive charge vs. characteristics characteristics
gc01mps12 - 214 1200 v sic mps? diode feb 2018 rev1.1 http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ i f = f(v f , t j ) figure 8 : forward curve model http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ i f = (v f C v bi )/r built-in voltage (v v bi (t j ) = m*t j + b, m = -1.25e- 03, b = 0.904 differential resistance (r r diff (t j ) = a*t j 2 + b*t a = 7.60e- 05, b = 8.48e : forward curve model http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ page 4 of 6 )/r diff voltage (v bi ): + b, 03, b = 0.904 differential resistance (r diff ): + b*t j + c (?); 05, b = 8.48e -03, c = 2.32
gc01mps12 - 214 1200 v sic mps? diode feb 2018 rev1.1 http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ package dimensions: do - 214 recommended solder pad layout note 1. controlled dimension is inch. dimension in bracket is m 2. dimensions do not include end flash, mold flash, material protrusions http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ package outline 1. controlled dimension is inch. dimension in bracket is m illimeter. 2. dimensions do not include end flash, mold flash, material protrusions http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ page 5 of 6
gc01mps12 - 214 1200 v sic mps? diode copyright ? 2018 genesic semiconductor inc. all rights reserved the information in this document is subject to change without feb 2018 rev1.1 http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ rohs compliance the levels of rohs restricted materials in this product are below the maximum concentration values (also referred to as the threshold limits) permitted for such substances, or are used in an exempted application, in accordance with eu directive 2011/65/ec (rohs2), as implemented january 2, 2013. rohs declarations for this product can be obtained from your genesic representative. reach compliance reach subs tances of high concern (svhcs) information is available for this product. since the european chemi (echa) has published notice of their intent to frequently revise the svhc listing for the foreseeable future, genesic representat ive to insure you get the most up information (reach article 67) is also available upon request. this product has not been designed or tested for use in, and is not intended for use in, applications i human body nor in applications in which failure of the product could lead to death, personal injury or property damage, including but not limited to equipment used in the operation of nuclear facilities, life def ibrillators or similar emergency medical equipment, aircraft navigation or communication or control systems, or air traffic control systems. genesic disclaims all and any warranty and liability arising out of use or application of any product. no license, implied to any intellectual property rights is granted by this document. related links ? soldering document: http://www.genesicsemi.com/quality/quality ? tin-whisker report: http://www.genesicsemi.com/quality/compliance/ ? reliability report: http://www.genesicsemi.com/quality/reliability/ copyright ? 2018 genesic semiconductor inc. all rights reserved the information in this document is subject to change without notice 43670 trade center place suite 155 http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/ the levels of rohs restricted materials in this product are below the maximum concentration values (also referred to as the such substances, or are used in an exempted application, in accordance with eu directive 2011/65/ec (rohs2), as implemented january 2, 2013. rohs declarations for this product can be obtained from your tances of high concern (svhcs) information is available for this product. since the european chemi (echa) has published notice of their intent to frequently revise the svhc listing for the foreseeable future, ive to insure you get the most up -to-date reach svhc declaration. reac article 67) is also available upon request. this product has not been designed or tested for use in, and is not intended for use in, applications i human body nor in applications in which failure of the product could lead to death, personal injury or property damage, including but not limited to equipment used in the operation of nuclear facilities, life - support machines, cardiac ibrillators or similar emergency medical equipment, aircraft navigation or communication or control systems, or air genesic disclaims all and any warranty and liability arising out of use or application of any product. no license, intellectual property rights is granted by this document. http://www.genesicsemi.com/quality/quality -manual/ http://www.genesicsemi.com/quality/compliance/ http://www.genesicsemi.com/quality/reliability/ published by genesic semiconductor, inc. 43670 trade center place suite 155 dulles, va 20166 page 6 of 6 the levels of rohs restricted materials in this product are below the maximum concentration values (also referred to as the such substances, or are used in an exempted application, in accordance with eu directive 2011/65/ec (rohs2), as implemented january 2, 2013. rohs declarations for this product can be obtained from your tances of high concern (svhcs) information is available for this product. since the european chemi cal agency (echa) has published notice of their intent to frequently revise the svhc listing for the foreseeable future, please contact a svhc declaration. reac h banned substance this product has not been designed or tested for use in, and is not intended for use in, applications i mplanted into the human body nor in applications in which failure of the product could lead to death, personal injury or property damage, support machines, cardiac ibrillators or similar emergency medical equipment, aircraft navigation or communication or control systems, or air genesic disclaims all and any warranty and liability arising out of use or application of any product. no license, express or
gc01mps12 - 214 1200 v sic mps? diode feb 2018 rev1.1 http://www.genesicse spice model parameters this is a s ecure document. please c opy this code from the spice model pdf file on our website ( http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/gc01mps12 into ltspice (version 4) sof tware for simulation of the g * genesic semiconductor sic mps * revision: 1.1 * date: february-2018 ************************************************************************** ** do-214 package ************************************************************************** .subckt gc01mps12 a k case l_anode a ad 5 d1 ad case gc0 l_cathode k case 5 .ends ************************************************************************** .subckt gc01mps 12 anode kathode d1 anode kathode gc01mps 12_schottky .model gc01mps 12_schottky d + is 1.01e- 15 + n 1 + eg 1.2 + trs1 0.005434 + cjo 9.48e-11 + m 0.438 + tt 1.00e-10 + ibv 0.1e-06 + iave 1 + mfg genesic_semi .ends * end of GC01MPS12-214 spice model ************************************************************************** * this model is provided "as is, where is, and with no warranty of any kind * either expressed or implied, including but not limited to any implie * warranties of merchantability and fitness for a particular purpose." http://www.genesicse mi.com/sic_rectifiers_diodes/merged_pin_schottky/ this is a s ecure document. please c opy this code from the spice model pdf file on our website http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/gc01mps12 tware for simulation of the g c01mps12-214. genesic semiconductor sic mps tm rectifier ************************************************************************** ************************************************************************** 5 n d1 ad case gc0 1mps12 5 n ************************************************************************** 12 anode kathode 12_schottky 12_schottky d 15 rs 0.622 ikf 500 xti 2 trs2 2.717e-05 vj 0.879 fc 0.5 bv 1600 vpk 1200 type sic_mps tm spice model ************************************************************************** this model is provided "as is, where is, and with no warranty of any kind * either expressed or implied, including but not limited to any implie * warranties of merchantability and fitness for a particular purpose." mi.com/sic_rectifiers_diodes/merged_pin_schottky/ page 1 of 1 this is a s ecure document. please c opy this code from the spice model pdf file on our website http://www.genesicsemi.com/sic_rectifiers_diodes/merged_pin_schottky/gc01mps12 -214_spice.pdf) ************************************************************************** ************************************************************************** ************************************************************************** ************************************************************************** this model is provided "as is, where is, and with no warranty of any kind * either expressed or implied, including but not limited to any implie d * warranties of merchantability and fitness for a particular purpose."
|
